Revitalizer™ Cleaner & Protector
Features + Benefits
- Cleans everyday messes while reinforcing protection
- Built-in sealer makes surfaces easier to clean
- Neutral, gentle formula
- Great for stone countertops and everywhere else
Where to Use
Natural stone such as marble, granite, limestone, slate, terrazzo, travertine & sandstone. Ceramic Porcelain & Tile. Best suited for
the most porous stone surfaces.
Directions
Note: Directions may vary depending on size.
- Spray directly on soiled area.
- Wipe clean with a dry towel, lint-free cloth or sponge. No need to rinse.
- Repeat for heavily soiled areas.
Available Sizes (and Coverage)
- 24 oz. Spray with Citrus or Cucumber scent
- Wipes: 35 Wipes, 7" x 9"
- Gallon Refill
- Gallon Concentrate: 2,000 - 10,000 sq. ft.
KlenzAll™
Features + Benefits
- Powers through stubborn grease & soils
- Safe on stone, will not etch
- Professional strength, alkaline formula
Where to Use
Natural stone such as marble, granite, limestone, travertine, slate, terrazzo & sandstone. Ceramic tile, porcelain tile & grout.
Masonry & concrete.
Directions
Note: Directions may vary depending on size. Always test in a small inconspicuous area to determine ease of use and desired
results. Make sure all surfaces to be cleaned are swept or vacuumed to remove loose debris.
- Spray directly on soiled area. Minimize overspray.
- Scrub with a clean, non-abrasive sponge or stiff nylon brush as needed.
- Wipe up with a clean dry towel, sponge or mop.
- For optimum results, rinse area well with clean water
- Reseal cleaned area.
Available Sizes (and Coverage)
- 24 oz. Spray
- Quart Concentrate: 500-4,000 sq. ft.
- Gallon Concentrate: 2,000-10,000 sq. ft.
Oil Stain Remover
Features + Benefits
- Pulls out deep, set-in oil stains
- Leaves no residue
- Will not discolor stone
- Easy to use, no messy plastic wrap needed
Where to Use
Natural stone such as marble, granite, limestone, travertine, slate, terrazzo & sandstone. Grout for ceramic & porcelain tile.
Masonry & concrete.
Directions
Always test in a small inconspicuous area to determine that the desired results will be achieved. Make sure surface is clean, dry
and free of waxes and coatings. .
- Using a plastic or wood spatula, stir thoroughly to mix the paste.
- Apply a 1/4” thick layer of paste to the stain. Insure that the paste extends at least 1"-2" beyond the edge of the stain.
- Do not cover.
- Allow 48-72 hours for paste to completely dry to a powder.
- Remove powder and discard.
- Allow solvent to completely dry from the stone.
- If stain is not completely gone after drying, repeat process.
- Clean up residue and tools with mineral spirits.
- Reseal cleaned area.
Available Sizes (and Coverage)
- 3 oz Can: 1/10-1/5 sq. ft. of surface at 1/4" thickness.
- Pint Can: ½-1 sq. ft. of surface at 1/4" thickness.
|